Why open estimates go cold
You drove out, measured, priced it and sent it. Then the customer went quiet, and the follow-up depends on someone remembering. Some estimates get three calls; most get none. Customers rarely say no outright. They get busy, compare a second quote, or wait for someone to make it easy. A short check-in at the right moments keeps your estimate in front of them, and the ones that are truly dead get closed out instead of cluttering the pipeline.
What Alvin does
- Reads estimates still open in your software. Approved or declined ones are left alone, and so is anyone on your never-contact list.
- Picks the right step. Day 2 asks if they have questions. Day 7 offers to walk through the options or put a start date on the calendar. Day 14 is a short check-in. Day 30 asks politely whether to close it out.
- Names the actual estimate. The job and its total, signed by the person you chose. No made-up deadlines or discounts.
- Waits for your OK. Every batch shows each exact email before anything goes out, from your Gmail or Outlook.
- Never repeats itself. Each step goes once. After 45 days with no answer, the estimate is listed for you to call or close, not emailed again.
Example
Example day-7 follow-up for a sample heating and air company. Names and amounts are examples.
Subject: Following up on your estimate
Hi Jordan,
Following up on the heat pump replacement estimate ($11,480.00). I’m happy to walk through the options or put a start date on the calendar whenever you’re ready.
Thanks,
Tomas
Sample Heating & Air
The same morning, Alvin lists two estimates past 45 days for Tomas to call himself or close out.
Rules it never breaks
These are built in. No setting turns them off.
- Every batch of emails waits for your OK of the exact words
- Only estimates still open in your software: approved or declined ones get nothing
- Each follow-up goes once; after 45 days it's listed for you, not emailed
- No made-up deadlines or discounts
Your settings
Each setting starts on a default that works:
- First follow-up: after 2 days, after a week, or after two weeks. Later starts skip the earlier steps.
- Signed by: the person whose first name goes at the end of every email, usually whoever wrote the estimate.
- Never contact: customers Alvin leaves alone, one per line.
- How messages are written: standard words, the same every time, or in your voice. In your voice, Alvin rewrites each email and keeps the exact amounts.
It runs every weekday at 10:00 AM, and a company sets it up once. Want to see it before you decide? Alvin lists your open estimates and the follow-up each would get while you’re still setting it up.
Frequently asked questions
How long should I wait to follow up on an estimate?
Two days is a good first check-in, while the visit is still fresh. Alvin follows up at day 2, 7, 14 and 30 by default, and you can start at a week or two weeks instead.
How many times should a contractor follow up on a quote?
Three or four short, useful touches are plenty. Alvin sends at most four, each once, then hands the estimate back to you after 45 days with no answer.
What if the customer already said yes?
Then they get nothing. Alvin only follows up on estimates still open in your software, so approved or declined estimates are skipped.
Will the emails pressure customers?
No. There are no made-up deadlines or discounts in Alvin’s follow-ups, and the day-30 note simply asks whether to close the estimate out.
Can I see example wording first?
Yes. Our estimate follow-up templates show messages you can copy, and Alvin shows every exact email before it sends.
Follow up on every open estimate this week.
Connect your estimate software and your mailbox, and see the follow-up each open estimate would get.
